FAQ
Questions, clearly answered.
How GRANDER works, how we install it, and what has been measured, including a Hong Kong data centre case study.
Where an answer depends on GRANDER’s own description, we say so. Where it depends on your site, we say that too.
Commercial
How is GRANDER used on chillers and cooling towers?
A GRANDER Circulation Revitalisation Device is fitted on the chilled-water or cooling circuit, with no power and no dosing. As described by GRANDER: less limescale and corrosion, more efficient cooling and boiler systems, and less maintenance. For cooling systems, GRANDER also states reduced maintenance and optimised chemical use. We usually begin with one circuit, then measure.
Do you work with data centres?
Yes. Commercial work leads with chillers and data-centre cooling, then offices, hotels and heating systems. At a Hong Kong data centre we measured about 14% less cooling energy and about 28% less water, with estimated savings of HK$399,134.50 a year. These are preliminary, site-specific results. See the case study.
How do you measure results on a commercial site?
We set a baseline on the site’s own meters first, then compare like for like, weather-adjusted where it matters. A typical project runs survey, installation, monitoring and support, with a results report against that baseline. We can pilot a single loop and report before you commit further.
Can GRANDER replace our existing water treatment?
Not necessarily. According to GRANDER, where conventional water treatment is required, GRANDER can support it but not replace it. We review your current treatment at the survey before recommending anything.
What about the building’s main water supply?
For hotels, restaurants and larger buildings, a Water Revitalisation Device goes on the main water supply, in main pipe sizes ¾″ up to 4″. It is sized to the pipe and peak usage at the survey.
Residential
What does a GRANDER unit do in a home?
One device on your supply treats every tap and shower in the home. As described by GRANDER: fine-tasting water, a pleasant shower, and savings on laundry and cleaning detergents. A GRANDER unit is not a filter. It does not remove lead, chlorine or other substances, and we make no health claims.
Where is the unit fitted in a house or a flat?
In a house or whole building, a Water Revitalisation Device sits on the main pipe after the water meter, so every tap downstream is covered. In a Hong Kong flat, an Apartment Unit fits on your own isolation valve, with no pipe cutting, no building-wide works and no change to your plumbing layout. A short survey tells you which device suits the site.
What if I only want it on one shower?
The GRANDER catalogue includes Inline Units W38 | W50 for secondary lines such as showers and sinks, in ⅜″ and ½″. For whole-home coverage, a main-supply device or Apartment Unit is the better choice.
How it works
How does a GRANDER unit work?
According to GRANDER, a sealed water core transfers information to the water flowing past it, without ever touching it. GRANDER water is sealed inside the unit and never mixes with your supply. Your water passes through the stainless-steel housing in normal use, in either direction. Process as described by GRANDER.
Is it a filter? Does it change hardness or remove chlorine?
No. It is not a filter: hardness and minerals stay as they are. It does not remove lead, chlorine or other substances, and we make no health claims. Nothing is added to the water, and nothing is removed. If you have concerns about your water quality, we recommend a suitably certified treatment product as well.
Does it need power or chemicals?
No. There is nothing to plug in and no running cost. No salt, additives or chemical dosing. The device is fitted once on the line or circuit.
Where are the units made?
According to GRANDER, every unit is filled at the family company’s headquarters in Jochberg, Tyrol, Austria, where the water for its sealed core is produced. Housings are stainless steel: V2A as standard, with V4A on request for special applications.
Installation and maintenance
How is a unit installed?
We start with a site survey and a written recommendation and quotation. Licensed contractors then fit the device, with permissions arranged first. You receive an installation record and hand-over. e-able coordinates the work; every project has a named contact from survey to hand-over.
What maintenance does it need?
Maintenance is minimal. The device is fitted once on the line or circuit. Circulation Revitalisation Devices for heating and chilled-water loops use no power, no dosing, and have nothing to replace. After installation we can monitor results against your baseline and stay on as a named contact for reviews.
How do you choose the size?
According to GRANDER, selection depends on pipe dimension, peak usage times, stress factor and the installation situation. The device is never smaller than the pipe it sits on. We check these at the survey and confirm the model in writing.
Where does a circulation device go on a heating circuit?
According to GRANDER, on the return flow, after a dirt separator, on a vertical pipe. On cooling and process circuits, the position is set after an on-site inspection. 3″ and 4″ units always go on a support bracket.
Proof and results
What results have you measured?
At a Hong Kong data centre, Phase 1 cooling (two cooling towers and three chillers) was compared from July–September 2025 with the same months in 2026, on the site’s own meters. Cooling energy fell by about 14% (61,288 kWh, weather-adjusted) and water use by about 28% (1,864 m³). Estimated savings are HK$399,134.50 a year, with a 4.8-year payback on the installation. Preliminary, site-specific results. The client is not named. See the full case study.
Are those results guaranteed at every site?
No. They are preliminary, site-specific results from one three-month comparison at one site. Energy was weather-adjusted with a simple CDD18 model; water was compared as metered. The annual figure multiplies the three-month saving by four. Outcomes vary by site, system and operation. We measure on your own meters rather than promising a fixed saving.
Can we see the method behind the figures?
Yes. The Proof page sets out the meters, the period, the weather adjustment, the rates used and the limits of the study. On your own site, you receive a written results report against your baseline.
Buying from e-able
Who is e-able?
e-able Limited is an official, authorised GRANDER distributor. We supply, install and support GRANDER water technology for residential, commercial and industrial sites. According to GRANDER, it is an Austrian, 100% family-owned company based in Jochberg, Tyrol, founded in 1979. Our office is at 11/F, Fun Tower, 35 Hung To Road, Kwun Tong, Kowloon, Hong Kong.
Is e-able authorised by GRANDER?
Yes. e-able is an official, authorised GRANDER distributor in Hong Kong.
Do you publish prices?
No. Prices and availability are given on request, because the device and size depend on your site. Email us for a written quotation after the survey.
How do I get started?
Email [email protected] to book a site survey. Please include the site address, the type of property (home, commercial or industrial) and a convenient time for a site visit. We typically start with one water line, one circuit or one building, measure on your own meters, then scale. We are in the office Monday to Friday, by appointment.
Still deciding? Start with a survey.
Tell us about your home, building or plant room. We reply by email with a clear next step, usually a site survey.
